高壓開關柜在線監測及斷路器行程信號的處理
張思宇，梅軍
東南大學 電氣工程學院, 江蘇 南京 210096
摘 要：提出了一種基于分布式結構和以太網通信方式的高壓開關柜在線監測系統，該系統采用高級RISC微處理器(ARM)與現場可編程門陣列(FPGA)構成的嵌入式數據采集與通信單元。針對在線監測系統采集到的斷路器行程信號，利用小波閾值消噪方法在消去噪聲的同時較好地保留了信號的特征，對于經過去噪處理的離散行程信號，在Matlab軟件中對其求微分，得到斷路器動觸頭速度的離散數據曲線，求得的速度最大點即為剛合點，進而可得出斷路器的開距、超程等參數，通過數據對比驗證了此方法的有效性和準確性。
關鍵詞：高壓開關柜；在線監測；行程信號；消噪
中圖分類號：TM561；TM591 文獻標識碼：A 文章編號：1007-3175(2013)12-0041-04
High-Voltage Switchgear Online Monitoring and Processing of Circuit Breakers Displacement Signal
ZHANG Si-yu, MEI Jun
School of Electrical Engineering, Southeast University, Nanjing 210096, China
Abstract: This paper raised a kind of high-voltage switchgear online monitoring system based on distributed structure and Ethernet communication. The system adopted the advanced reduced instruction set computer (RISC) microprocessor (ARM) and field programmable gate array (FPGA) to constitute embedded data collecting and communication unit. In allusion to circuit breakers displacement signal of on-line monitoring system, wavelet threshold denoising method was used to remain characteristics of signals while denoising. The denoising dispersed displacement signals were differential in Matlab to obtain dispersed data curves of circuit breakers moving contacts speed. The maximum point of speed is the closing point, thus further to get open gap of circuit breakers, over distance etc parameters. Data comparison verifies the validity and correctness of the method.
Key words: high-voltage switchgear; on-line monitoring; displacement signal; de-noising
參考文獻
[1] 高翔.數字化變電站應用技術[M].北京：中國電力出版社，2008.
[2] 郭媛媛，榮命哲，徐鐵軍，等.基于雙CPU的斷路器在線監測裝置主控單元的研制[J].電氣技術，2005，6(12)：20-23.
[3] 周偉.基于MATLAB的小波分析應用[M].2版.西安：西安電子科技大學出版社，2010.
[4] 向曉燕，譚子尤，張書真.基于小波的閥值消噪方法討論及實現[J].現代電子技術，2007(17)：172-176.
[5] 吳振升，王瑋，楊學昌，等.基于小波算法的SF6斷路器動作時間在線監測[J].中國電力，2006，39(6)：26-29.
[6] 楊賽男.高壓開關柜智能在線監測與診斷系統關鍵技術的研究[D].南京：東南大學，2013.
